20 Gauge Pittsburgh
The Lockformer “Standard” 20 Gauge Pittsburgh Machine has 5 forming stations with one (1) inboard forming position for the 5/16” Pittsburgh Lock and one (1) outboard station for Auxiliary Roll Sets. It is a stand-alone machine that has a 3/4 HP Motor and runs on 115 Volt, Single Phase Power with 25 FPM running speed. Over time, you may have to replace the Pittsburgh opening roll, opening roll spring and opening roll holder. It is also common to replace certain gears and forming rolls, including the Bottom 1 and Top 4 & 5 Rolls. We are proud to offer official Lockformer-brand replacement parts for your 20 Gauge Pittsburgh Machine. Please review the parts list to find the replacement parts you need and contact us if you need assistance.
20 Gauge Pittsburgh
-
L-14623 - Saddle Washer
$164.96 -
L-20041 - Upper Plate, Left
$440.77 -
L-20042 - Upper Plate, Right
$440.77 -
L-20043 - Lower Plate, Left
$1,635.97 -
L-20044 - Lower Plate, Right
$646.71 -
L-21811 - Opening Roll Holder (OLD PART NO. - ORDER New Part #52500)
-
L-29802 - Gauge Bar, Entrance and Exit
$70.09 -
L-51627 Opening Roll - 20 Ga. Pittsburgh
$37.50 -
L-52500 Opening Roll Holder - 20 Ga. Pittsburgh (Old Part #21811)
$175.00 -
L-60048 5/16 - 18 x 1-1/4 HHCS
$1.97 -
L-60154 1/2-13 x 1-1/2 HHCS HT
$1.97 -
L-60228 - 1/2-13 x 1-3/4 Hex CS
$1.97 -
L-60252 - Hold Down Stud - 5/8-11 x 6
$4.11 -
L-60450 - 1/2-13 x 1 SHCS
$1.97 -
L-60551 - 1/4-20 x 1/2 RHMS
$1.97 -
L-60650 - 5/16-18 x 5/16" SSS
$1.97 -
L-60750 - 1/4 - 20 x 1/2 SHSS
$1.97 -
L-60777 - 3/8-16 x 3/4 - SHSS
$1.97 -
L-60778 Set Screw
$1.97 -
L-60875 - 3/8-16 x 1 Carriage Bolt
$1.97 -
L-60877 - 3/8 x 1-3/4 Carriage Bolt
$1.97 -
L-60953 - 3/8-16 x 1 FH SCS
$1.97 -
L-61120 - 3/8-16 HN - Hex Nut
$1.97 -
L-62010 - 5/16 x 1/16 Flat Washer
$1.97